Overview
The Multiple Pattern Support on a Voice Dial Peer feature enables you to configure multiple patterns on a VoIP dial peer using an E.164 pattern map. A dial peer can be configured to match multiple patterns to an incoming calling or called number or an outgoing destination number.
Matching an incoming or outgoing call using a pattern defined in a VoIP dial peer is an existing feature on the Cisco Unified Border Element (Enterprise) and Session Initiation Protocol (SIP) Gateway. You can now support multiple patterns on a VoIP dial peer using an E.164 pattern map. You can create an E.164 pattern map and then link it to one or more VoIP dial peers.
When a pattern is the only source to enable a dial peer, a valid E.164 pattern map enables the linked dial peers, whereas an invalid E.164 pattern map disables the linked dial peers. Additionally, whenever an E.164 pattern map is created or reloaded, one or more dial peers linked with an E.164 pattern map is enabled or disabled based on the validation of a pattern map.
You can match a pattern map to an incoming calling or called number or an outgoing destination number.
When a dial peer has multiple patterns, the pattern with the longest prefix is considered as the matching criteria.
Feature Information for Multiple Pattern Support on a Voice Dial Peer
The following table provides release information about the feature or features described in this module. This table lists only the software release that introduced support for a given feature in a given software release train. Unless noted otherwise, subsequent releases of that software release train also support that feature.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support. To access Cisco Feature Navigator, go to www.cisco.com/go/cfn. An account on Cisco.com is not required.
Feature Name |
Releases |
Feature Information |
---|---|---|
Configuring Multiple Pattern Support on a Voice Dial Peer (Inbound Calls) |
Cisco IOS 15.4 (1)T Cisco IOS XE 3.11S |
This feature was extended for inbound VoIP dial peers for incoming calling and called numbers. The following commands were introduced or modified: incoming called e164-pattern-map , incoming calling e164-pattern-map |
Configuring Multiple Pattern Support on a Voice Dial Peer (Outbound Calls) |
Cisco IOS 15.2(4)M Cisco IOS XE 3.7S |
This feature allows you to add more than one E.164 destination pattern inside a pattern map and configure that pattern map for one or more VoIP dial peers. This feature is supported for outbound peers only. The following commands were introduced or modified: destination e164-pattern-map , e164 , show voice class e164-pattern-map , url , voice class e164-pattern-map load , voice class e164-pattern-map . |