Cisco NDFC SAN Controller Configuration Guide, Release 12.0.x

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: December 17, 2021

Active Zones

Regular Zones

You can view all the Regular Zones that are configured on SAN Controller. Choose SAN > Active Zones > Regular Zones tab. The following table describes the fields that appear on this screen.

Table 1.

Field

Description

Group

Specifies the name of the fabric.

VSANS

Specifies the number of VSANS configured on this Zone.

Zone Sets

Specifies the name of zone set to which the zone belongs.

Zone

Displays the zone under which this member is present.

Note

You cannot save any changes made to topology layout from this screen.

Switch Interface/WWN

Specifies the switch interface or WWN of the switch that the zone member is attached to.

PWWN

Specifies the associated pWWN to the switch.

Member Name

Displays the name of the zone member.

Zoned By

Displays the type of zoning. You can search by type of zoning such as WWN, FCID, fcAlias, or iSCSI.

IVR Zones

You can view all the IVR Zones configured on SAN Controller. Choose SAN > Active Zones > IVR Zones tab. The following table describes the fields that appear on this screen.

Table 2.
Field	Description
Group	Specifies the fabric name.
VSANS	Specifies the number of VSANS configured on this Zone.
Zone Sets	Specifies the name of Zone set to which the zone belongs.
Zone	Displays the zone under which this member is present.
Switch Interface/WWN	Specifies the switch interface or WWN of the switch that the zone member is attached to.
PWWN	Specifies the associated pWWN to the switch.
Member Name	Displays the name of the zone member.
Zoned By	Displays the type of zoning. You can search by type of zoning such as WWN, FCID, fcAlias, or iSCSI.

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)