- Welcome to the Cisco Nexus 3550F Fusion Documentation
-
- Command Line Interface
- Configuration Management
- User Management
- Diagnostics
- Statistics Logging
- Configuring Ports
- Packet Capture
- Patches and Taps
- FPGA Module
- Switch Objects
- Mux Objects
- MAC Address Table
- IGMP and Multicast
- VLAN Support
- Mirror and Timestamping Fusion
- Mirror and Timestamping Fusion HPT
- Virtual Ports
- LLDP
- SNMP
- TACACS+
- Access Control
- Latency Statistics
- BGP
- Bash Shell
- Automatic Configuration
- Known Issues
Rebooting
The reboot command can be used to reset the Cisco Nexus 3550-F Fusion (formerly ExaLINK Fusion) and load the startup-config on boot.
admin@N3550-F> reboot
Are you sure you want to reboot this device? y
Rebooting system
Connection to EXALINK-FUSION closed by remote host.
Connection to EXALINK-FUSION closed.
Delayed Reboot
The Nexus 3550-F can be instructed to reboot at a given time in the future using the reboot in command. This can be useful when changing the management interface settings of a Nexus 3550-F at a remote site, where there is concern that an mistake in setting the config would disrupt 459647 to the CLI and prevent rollback of the incorrect config.
admin@N3550-F> reboot in
Usage: reboot in [<hh>:]<mm>
Schedule a reboot of the device
admin@N3550-F> reboot in 2
Rebooting in 2 minutes
Use "reboot cancel" command to cancel reboot
WARNING: Rebooting in 1 minute 59 seconds
Tapping enter on the CLI will show the remaining time left before the device will reset itself:
admin@N3550-F>
WARNING: Rebooting in 1 minute 45 seconds
admin@N3550-F>
WARNING: Rebooting in 1 minute 44 seconds
admin@N3550-F>
WARNING: Rebooting in 1 minute 44 seconds
admin@N3550-F>
WARNING: Rebooting in 1 minute 43 seconds
The delayed reboot can be cancelled using the reboot cancel command:
admin@N3550-F> reboot cancel
Scheduled reboot canceled
Feedback