Configuring and Validating High Efficiency (802.11 ax)

Configuring and Validating High Efficiency

When High Efficiency (HE) is enabled, it is backward compatible with 802.11ac. To enable or disable 802.11ax HE, the following list is supported.

  • Cisco URWB HE supports 20/40/80 MHz bandwidth for slot 1.

  • Cisco URWB HE supports 20/40/80/160 MHz bandwidth for slot 2.

  • Cisco URWB, HE defaults setting is disabled.

  • HE negotiation is only supported between devices with HE enabled.

To enable High Efficiency mode, use the following CLI commands.

Device# configure dot11Radio [1|2] high-efficiency enable
Device# configure dot11Radio [1|2] mcs maxmcs <mcs index in integer or string>

Note


Need to configure maxmcs as 11 by CLI “configure dot11Radio 1/2 mcs maxmcs 11” since default maxmcs is 9.


To disable High Efficiency mode, use the following CLI commands:

Device# configure dot11Radio [1|2] high-efficiency disable
default maxmcs is 9.

To validate High Efficiency mode, use the following show command.

Device# show dot11Radio 1 config
Maximum tx mcs : 9
High-Efficiency : Enabled
Maximum tx nss : 2
RTS Protection : disabled
guard-interval : 800ns
Device# show dot11Radio 2 config
Maximum tx mcs : 9
High-Efficiency : Enabled
Maximum tx nss : 2
RTS Protection : disabled
guard-interval : 800ns
Device# show eng-stats

WLAN1 Rx:

FC:58:9A:16F8:52 rate 1201 MCS 11/2 HE80/G1(800ns) ssn 48 rssi-48 received

WLAN1 Tx:

FC:58:9A:16F8:52 rate 1201 MCS 11/2 HE80/G1(800ns) sent 195612 failed 0

WLAN2 Rx:

FC:58:9A:16F8:13 rate 1201 MCS 11/2 HE80/G1(800ns) ssn 50 rssi-46 received

WLAN2 Tx:

FC:58:9A:16F8:13 rate 864 MCS 11/2 HE80/G1(800ns) sent 390797 failed 1

Configuring Global Gateway from GUI

Global gateway mode automatically enforces MPLS (Multi-Protocol Label Switching) layer 3 and radio-off and radio status cannot be changed in global gateway mode. The below images show the GUI configuration of global gateway mode.