Verifying the Configuration
You can use a number of commands to verify the configuration of your feature, service, or system. Many are hierarchical in their implementation and some are specific to portions of or specific lines in the configuration file.
Feature Configuration
In many configurations, you have to set and verify specific features. An example includes IP address pool configuration. Using the example below, enter the listed commands to verify proper feature configuration.
Enter the show ip pool command to display the IP address pool configuration. The output from this command should look similar to the sample shown below. In this example, all IP pools were configured in the isp1 context.
context : isp1:
+-----Type: (P) - Public (R) - Private
| (S) - Static (E) - Resource
|
|+----State: (G) - Good (D) - Pending Delete (R)-Resizing
||
||++--Priority: 0..10 (Highest (0) .. Lowest (10))
||||
||||+-Busyout: (B) - Busyout configured
||||||
vvvvvv Pool Name Start Address Mask/End Address Used Avail
----- --------------------- -------------- --------------- ----------------
PG00 ipsec 12.12.12.0 255.255.255.0 0 254
PG00 pool1 10.10.0.0 255.255.0.0 0 65534
SG00 vpnpool 192.168.1.250 92.168.1.254 0 5
Total Pool Count: 5 Important |
To configure features on the system, use the show commands specifically for these features. Refer to the Exec Mode show Commands chapter in the Command Line Interface Reference for complete information. |
Service Configuration
Verify that your service was created and configured properly by entering the following command:
show service_type service_name The output is a concise listing of the service parameter settings similar to the sample displayed below. In this example, a P-GW service called pgw is configured.
Service name : pgw1
Service-Id : 1
Context : test1
Status : STARTED
Restart Counter : 8
EGTP Service : egtp1
LMA Service : Not defined
Session-Delete-Delay Timer : Enabled
Session-Delete-Delay timeout : 10000(msecs)
PLMN ID List : MCC: 100, MNC: 99
Newcall Policy : None Context Configuration
Verify that your context was created and configured properly by entering the show context name name command.
The output shows the active context. Its ID is similar to the sample displayed below. In this example, a context named test1 is configured.
Context Name ContextID State
------------ --------- -----
test1 2 Active System Configuration
Verify that your entire configuration file was created and configured properly by entering the show configuration command.
This command displays the entire configuration including the context and service configurations defined above.
Finding Configuration Errors
Identify errors in your configuration file by entering the show configuration errors command.
This command displays errors it finds within the configuration. For example, if you have created a service named "service1", but entered it as "srv1" in another part of the configuration, the system displays this error.
You must refine this command to specify particular sections of the configuration. Add the section keyword and choose a section from the help menu as shown in the examples below.
show configuration errors section ggsn-service or
show configuration errors section aaa-config If the configuration contains no errors, an output similar to the following is displayed:
##############################################################################
Displaying Global
AAA-configuration errors ##############################################################################
Total 0 error(s) in this section ! 
Feedback