Open Caveats in Cisco Smart PHY 24.1.1
There are no new open caveats in the Cisco Smart PHY 24.1.1 release.
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes open severity 1 and 2 caveats and select severity 3 caveats.
The Open Caveats section lists open caveats that apply to the current release and may apply to previous releases. A caveat that is open for a prior release and is still unresolved applies to all future releases until it is resolved.
The bug IDs are sorted alphanumerically.
The Caveats section includes the bug ID and a short description of the bug. For details on the symptoms, conditions, and workaround for a specific caveat you must use the Bug Search Tool.
There are no new open caveats in the Cisco Smart PHY 24.1.1 release.
Identifier |
Headline |
---|---|
After a Smart PHY upgrade, cBR-8 is appearing offline in Smart PHY UI |
|
Support overlapping US bonding group with MD Split in Smart PHY |
|
Incorrect deviation seen after modifying Latitude / Longitude values for Video Cores |
|
Incorrect reconcile report in 2x4 RPD for DS 1st Logical Pairing RF parameters |
|
Incorrect deviation report seen for US Port #1 RF Profile in 1x2 RPD |
|
The primary-vip-ipv6 for any MN setup should have a CIDR value in between the range 1 to 112 |
|
Smart PHY generates extra channels in fiber-node that were not defined in service group profile |
|
SSH algorithm mismatch warning seen in cBR8 |
|
Reconciliation shows deviation when 2x2 RPD configured on same data and video are same |
|
cBR8 is not coming online in Smart PHY because of AAA authentication failure |
|
Reconciliation reports config deviation for 2x4 when none is present |
Identifier |
Headline |
---|---|
After a Smart PHY upgrade, cBR-8 is appearing offline in Smart PHY UI |
|
Support overlapping US bonding group with MD Split in Smart PHY |
Identifier |
Headline |
---|---|
DSG TgList is not reconciled properly |
|
Highlighted Configuration deviation was offset by one line in the reconcile report |
|
Service definition 1/3 side bar displays values as "-" when set to "0" |
|
Health Monitoring & RBAC APIs fail with 500/401 error inconsistently |
Use the Cisco Bug Search Tool to access open and resolved bugs for a release.
The tool allows you to search for a specific bug ID, or for all bugs specific to a product and a release.
You can filter the search results by last modified date, bug status (open, resolved), severity, rating, and support cases.
For information on obtaining documentation, using the Cisco Bug Search Tool (BST), submitting a service request, and gathering additional information, see What’s New in Cisco Product Documentation.
To receive new and revised Cisco technical content directly to your desktop, you can subscribe to the What’s New in Cisco Product Documentation RSS feed. The RSS feeds are a free service.