IMM Commands

imm address

To configure the static IP address of the IMM, use the imm address command.

imm address ip-addr netmask gateway

Syntax Description

ip-addr

IP address of the IMM

netmask

Netmask of the IMM

gateway

Gateway of the IMM

Command Default

None

Command History

Release Modification
7.6 This command was introduced in a release earlier than Release 7.6.
8.0 This command supports only IPv4 address format.

Examples

The following example shows how to set the static IP address of an IMM: 

(Cisco Controller) >imm address 209.165.200.225 255.255.255.224 10.1.1.1

imm dhcp

To configure DHCP for the IMM, use the imm dhcp command.

imm dhcp { enable | disable | fallback}

Syntax Description

enable

Enables DHCP for the IMM

disable

Disables DHCP for the IMM

fallback

Enables DHCP for the IMM, but if it fails, then uses static IP of the IMM

Command Default

DHCP for IMM is enabled.

Command History

Release Modification
7.6 This command was introduced in a release earlier than Release 7.6.

Examples

The following example shows how to enable DHCP for the IMM: 

(Cisco Controller) >imm dhcp enable

imm mode

To configure the IMM mode, use the imm mode command.

imm mode { shared | dedicated}

Syntax Description

shared

Sets IMM in shared mode

dedicated

Sets IMM in dedicated mode

Command Default

Dedicated

Command History

Release Modification
7.6 This command was introduced in a release earlier than Release 7.6.

Examples

The following example shows how to set the IMM in shared mode: 

(Cisco Controller) >imm mode

imm restart

To restart the IMM, use the imm restart command.

imm restart

Syntax Description

restart

Saves your settings and restarts the IMM

Command Default

None

Command History

Release Modification
7.6 This command was introduced in a release earlier than Release 7.6.

imm summary

To view the IMM parameters, use the imm summary command.

imm summary

Syntax Description

summary

Lists the IMM parameters

Command Default

None

Command History

Release Modification
7.6 This command was introduced in a release earlier than Release 7.6.

Examples

The following example shows a typical summary of the IMM: 

(Cisco Controller) >imm summary
User ID..........................................username1
Mode............................................. Shared
DHCP............................................. Enabled
IP Address....................................... 209.165.200.225
Subnet Mask...................................... 255.255.255.224
Gateway.......................................... 10.1.1.1

imm username

To configure the logon credentials for an IMM user, use the imm username command.

imm username username password

Syntax Description

username

Username for the user

password

Password for the user

Command Default

None

Command History

Release Modification
7.6 This command was introduced in a release earlier than Release 7.6.

Examples

The following example shows how to set the logon credentials of an IMM user: 

(Cisco Controller) >imm username username1 password1