- Index
- Preface
- Product Overview
- Command-Line Interfaces
- Smart Port Macros
- Virtual Switching Systems (VSS)
- Enhanced Fast Software Ugrade (eFSU)
- NSF with SSO Supervisor Engine Redundancy
- RPR Supervisor Engine Redundancy
- Interface Configuration
- UniDirectional Link Detection (UDLD)
- Power Management and Environmental Monitoring
- EnergyWise
- Online Diagnostics
- Onboard Failure Logging
- Switch Fabric Functionality
- Cisco IP Phone Support
- Power over Ethernet
- Layer 2 LAN Ports
- Flex Links
- EtherChannels
- mLACP for Server Access
- IEEE 802.1ak MVRP and MRP
- VLAN Trunking Protocol (VTP)
- VLANs
- Private VLANs (PVLANs)
- Private Hosts
- IEEE 802.1Q Tunneling
- Layer 2 Protocol Tunneling
- STP and MST
- Optional STP Features
- Layer 3 Interface Configuration
- Unidirectional Ethernet (UDE) and unidirectional link routing (UDLR)
- Multiprotocol Label Switching (MPLS)
- L2VPN Advanced VPLS (A-VPLS)
- IP Unicast Layer 3 Switching
- IPv6 Multicast Layer 3 Switching
- MLD Snooping for IPv6 Multicast Traffic
- IPv4 Multicast Layer 3 Switching
- IGMP Snooping and MVR for IPv4 Multicast Traffic
- Configuring MVR for IPv4 Multicast Traffic
- IPv4 IGMP Filtering and Router Guard
- PIM Snooping
- IPv4 Multicast VPN Support
- PFC QoS
- AutoQoS
- MPLS QoS
- PFC QoS Statistics Data Export
- Network Security
- AutoSecure
- Cisco IOS ACL Support
- Cisco TrustSec (CTS)
- Port ACLs (PACLs) and VLAN ACLs (VACLs)
- Denial of Service Protection
- Control Plane Policing (CoPP)
- DHCP Snooping
- IP Source Guard
- Dynamic ARP Inspection
- Traffic Storm Control
- Unknown Unicast and Multicast Flood Control
- Network Admission Control (NAC)
- IEEE 802.1X Port-Based Authentication
- Web-Based Authentication
- Port Security
- NetFlow
- NetFlow Data Export (NDE)
- Call Home
- System Event Archive (SEA)
- Backplane Platform Monitoring
- SPAN, RSPAN, and ERSPAN
- SNMP IfIndex Persistence
- Top-N Reports
- Layer 2 Traceroute Utility
- Mini Protocol Analyzer
- Ethernet Services Line Cards
- Online Diagnostic Tests
- Acronyms
Preface
This preface describes who should read the Cisco IOS Software Configuration Guide, Release 12.2SX , and its document conventions.
Audience
This guide is for experienced network administrators who are responsible for configuring and maintaining the switches supported in Cisco IOS Release 12.2SX.
Related Documentation
The following publications are available for Cisco IOS Release 12.2SX:
•Catalyst 6500 Series Switch Installation Guide
•Catalyst 6500 Series Switch Module Installation Guide
•Cisco IOS Master Command List
•Catalyst 6500 Series Switch Cisco IOS System Message Guide, Release 12.2SX
•Release Notes for Cisco IOS Release 12.2SX
•Cisco IOS Configuration Guides and Command References:
http://www.cisco.com/en/US/products/hw/switches/ps708/tsd_products_support_series_home.html
•For information about MIBs, go to this URL:
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
Conventions
This document uses the following conventions:
Notes use the following conventions:
Note Means reader take note. Notes contain helpful suggestions or references to material not covered in the publication.
Cautions use the following conventions:
Obtaining Documentation, Obtaining Support, and Security Guidelines
For information on obtaining documentation, obtaining support, providing documentation feedback, security guidelines, and also recommended aliases and general Cisco documents, see the monthly What's New in Cisco Product Documentation, which also lists all new and revised Cisco technical documentation, at:
http://www.cisco.com/en/US/docs/general/whatsnew/whatsnew.html
Tip For additional information about Cisco Catalyst 6500 Series Switches (including configuration examples and troubleshooting information), see the documents listed on this page:
http://www.cisco.com/en/US/products/hw/switches/ps708/tsd_products_support_series_home.html
Participate in the Technical Documentation Ideas forum