New and Changed Information
|
Feature |
Description |
Changed in Release |
Where Documented |
|---|---|---|---|
|
UDP services identification |
Added UDP port(s) configuration to mask the exported flows for Traffic Analytics. |
10.5(2)F |
|
|
Single drop identification |
Added support to identify drop reasons in a single switch. |
10.5(2)F |
|
|
SNMP AES 256 support |
Introduced AES-256 as the privacy protocol for SNMPv3. |
10.5(2)F |
|
|
Support for EPLD using SNMP on N9K-X9736C-FX3 |
Added support for EPLD firmware version using SNMP on N9K-X9736C-FX3 line card |
10.5(1)F |
|
|
PTP Time Distribution Hold |
Added support for holding time distribution until a BC node locks to primary time source and settles down to the target correction value. |
10.5(1)F |
|
|
PTP high-correction notification enhancement |
Added more attributes to PTP high-correction notification |
10.5(1)F |
|
|
Traffic analytics enhancement |
Traffic anlaytics feature is enhanced to support higher cadence for TA troubleshooting rules and provide granular support for TA feature by allowing filters at the interface and VRF level. |
10.5(1)F |
Configuring Traffic Analytics |
|
PID-specific SMUs |
Added support for installation of PID-specific SMUs only on the PIDs they are meant for |
10.5(1)F |
|
|
SMU Retry/Reload Switch if SMU install Fails |
Added support to reload the switch automatically when a valid and compatible SMU that needs to be activated, fails to activate |
10.5(1)F |
Feedback