application
configure
|
Configures a specific application.
|
application
install
|
Installs a specific application.
|
application
remove
|
Removes a specific application.
|
application reset-config
|
Resets
application configuration to factory defaults.
|
application reset-passwd
|
Resets
application password for a specified user.
|
application
start
|
Starts or enables a specific application
|
application
stop
|
Stops or disables a specific application.
|
application
upgrade
|
Upgrades a specific application.
|
backup
|
Performs a backup (Cisco ISE and Cisco ADE OS) and places the
backup in a repository.
|
backup-logs
|
Performs a backup of all logs in the Cisco ISE server to a
remote location.
|
clock
|
Sets the system clock in the Cisco ISE server.
|
configure
|
Enters configuration mode.
|
copy
|
Copies any file from a source to a destination.
|
debug
|
Displays any errors or events for various command situations;
for example, backup and restore, configuration, copy, resource locking, file
transfer, and user management.
|
delete
|
Deletes a file in the Cisco ISE server.
|
dir
|
Lists files in the Cisco ISE server.
|
forceout
|
Forces the logout of all sessions of a specific Cisco ISE node
user.
|
halt
|
Disables or shuts down the Cisco ISE server.
|
mkdir
|
Creates a new directory.
|
nslookup
|
Queries the IPv4 or IPv6 address or hostname of a remote system.
|
password
|
Updates
the CLI account password.
|
patch
|
Installs a Patch Bundle or uninstalls an Application patch.
|
ping
|
Determines the IPv4 address or hostname of a remote system.
|
ping6
|
Determines the IPv6 address of a remote system.
|
reload
|
Reboots the Cisco ISE server.
|
restore
|
Performs a restore and retrieves the backup out of a repository.
|
rmdir
|
Removes an existing directory.
|
show
|
Provides information about the Cisco ISE server.
|
ssh
|
Starts an encrypted session with a remote system.
|
tech
|
Provides Technical Assistance Center (TAC) commands.
|
terminal
length
|
Sets terminal line parameters.
|
terminal
session-timeout
|
Sets the inactivity timeout for all terminal sessions.
|
terminal
session-welcome
|
Sets the welcome message on the system for all terminal
sessions.
|
terminal
terminal-type
|
Specifies the type of terminal connected to the current line of
the current session.
|
traceroute
|
Traces the route of a remote IP address.
|
undebug
|
Disables the output (display of errors or events) of the debug
command for various command situations; for example, backup and restore,
configuration, copy, resource locking, file transfer, and user management.
|
write
|
Erases the startup configuration that forces to run the setup
utility and prompt the network configuration, copies the running configuration
to the startup configuration, displays the running configuration on the
console.
Note
|
Cisco ISE Release 3.2 onwards, this command is modified to no longer support running-config and startup-config functions.
|
|