Configuration Catalog


Note


Cisco provides the configurations below "as is" for your convenience. These configurations have been built using industry best practices, observed across multiple deployments, which may be beneficial to you. Cisco is not responsible for any technical issues, bugs, or other issues that may arise from your use of these configurations and any resulting indirect, incidental, reliance, consequential, special or exemplary damages or loss of actual or anticipated revenue, profit, business, savings, data goodwill or use, business interruption, damaged data, wasted expenditure or delay in delivery (in all cases, whether direct or indirect).


Configuration Catalog

Table 1. Feature History

Feature Name

Release Information

Description

Configuration Catalog

Cisco IOS XE Catalyst SD-WAN Release 17.15.1a

Cisco Catalyst SD-WAN Manager Release 20.15.1

This feature provides a catalog of pre-defined configurations and policies. The Cisco Catalyst SD-WAN Portal hosts the catalog service, which is managed by Cisco.

Cisco SD-WAN Manager connects to the cloud-hosted Cisco Catalyst SD-WAN Portal to download catalog entries. You can modify the catalog entries before deploying them to devices in your network.

Information About the Configuration Catalog

The Configuration Catalog feature provides a validated set of configurations and policies that you can use for setting up the Cisco Catalyst SD-WAN network.

Cisco SD-WAN Manager is connected to the catalog service hosted in the Cisco Catalyst SD-WAN Portal. You can enable the connectivity between the catalog portal and Cisco SD-WAN Manager using smart account credentials.

Restrictions for the Configuration Catalog

The catalog service supports only configuration groups, policy groups, and topology groups. There is no support for templates or legacy policies.

Install a Catalog Entry

Before You Begin

Enable Cloud Services from the Administration > Settings > Cloud Services page to enable the Configuration Catalog page.

  1. From the Cisco SD-WAN Manager menu, click Configuration > Configuration Catalog.

  2. Choose the catalog entry label from the Choose labels drop-down list to view the available catalogs.

  3. Click View details on a specific catalog entry to check catalog entry details, detailed description, and customizable and default field information.

  4. Click Install to install the catalog entry to your configuration or Uninstall to uninstall the catalog entry from your configuration.


Note


You cannot add additional features to the configurations after it is installed. However, you can copy and modify the features if needed.