Release Notes for Cisco NCS 4201 and Cisco NCS 4202 Series, Cisco IOS XE 17.13.x

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: November 23, 2023

Chapter: What's New for Cisco IOS XE 17.13.x

What's New for Cisco IOS XE 17.13.x
What's New in Hardware for Cisco IOS XE 17.13.1
What's New in Software for Cisco IOS XE 17.13.1

What's New for Cisco IOS XE 17.13.x

This chapter describes the new hardware and software features that are supported on the Cisco NCS 4201 and Cisco NCS 4202 Series routers.

For information on features supported for each release, see Feature Compatibility Matrix.

What's New in Hardware for Cisco IOS XE 17.13.1

There are no new hardware features for this release.

What's New in Software for Cisco IOS XE 17.13.1


Feature	Description
T1/E1 CEM Interface Module
Framed SAToP System BERT	You can configure SATOP system BERT with framing under CEM circuits on T1 or E1 interfaces and verify if the BERT is stable and transmitted end-to-end.
User-defined Remote Loopback on T1 Interfaces	You can customize the loopback codes on T1 in a 16-bit format in contrast to the standard 6-bit loop code on the 48-port T1 interface module.

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)