The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
Place the Cisco Catalyst Wireless Gateway on a flat surface, with access to a household power outlet and to an ethernet connection providing internet connectivity. The device has two rubber pads for resting on a desk or shelf. No special hardware is required for mounting.
The dimensions of the device are shown in the following illustration.
For LTE models, install one or two SIM cards to provide cellular connectivity. For an illustration of the SIM card slots, see SIM Card Slots.
Small Phillips-head screwdriver
On the bottom of the Cisco Catalyst Wireless Gateway, open the cover for the SIM slots using the a small Phillips-head screwdriver.
Install either one (1) or two (2) SIM cards in the two slots, marked 0 and 1.
If you are installing two SIM cards, make note of which SIM card you place in each slot. This information is required during configuration of the two slots as primary and secondary.
Replace the cover for the SIM slots.
Connect the power adapter to an household power outlet, and connect its cable to the USB-C port on the back of the Cisco Catalyst Wireless Gateway.
Ensure that the power cable is properly secured.
Ensure that any data cables connected to the device are properly secured.
|
Connection |
Description |
|---|---|
|
Internet |
Connect the device to a WAN providing internet access, using the 2.5 Gbps ethernet interface. |
Feedback