- About this Guide
- Chapter 1, ML-Series Card Overview
- Chapter 2, CTC Operations
- Chapter 3, Initial Configuration
- Chapter 4, Configuring Interfaces
- Chapter 5, Configuring POS
- Chapter 6, Configuring Bridges
- Chapter 7, Configuring STP and RSTP
- Chapter 8, Configuring VLANs
- Chapter 9, Configuring IEEE 802.1Q Tunneling and Layer 2 Protocol Tunneling
- Chapter 10, Configuring Link Aggregation
- Chapter 11, Configuring Network Protocols
- Chapter 12, Configuring IRB
- Chapter 13, Configuring VRF Lite
- Chapter 14, Configuring Quality of Service
- Chapter 15, Configuring the Switching Database Manager
- Chapter 16, Configuring Access Control Lists
- Chapter 17, Configuring Cisco Proprietary Resilient Packet Ring
- Chapter 18, Configuring Ethernet over MPLS
- Chapter 19, Configuring Security for the ML-Series Card
- Chapter 20, POS on ONS Ethernet Cards
- Chapter 21, Configuring RMON
- Chapter 22, Configuring SNMP
- Chapter 23, E-Series and G-Series Ethernet Operation
- Chapter 24, CE-100T-8 Ethernet Operation
- Chapter 25, CE-1000-4 Ethernet Operation
- Chapter 26, Configuring IEEE 802.17b Resilient Packet Ring
- Appendix A, Command Reference
- Appendix B, Unsupported CLI Commands
- Appendix C, Using Technical Support
- Unsupported Privileged Exec Commands
- Unsupported Global Configuration Commands
- Unsupported POS Interface Configuration Commands
- Unsupported POS Interface Configuration Commands (Cisco Proprietary RPR Virtual Interface)
- Unsupported IEEE 802.17 RPR Interface Configuration Commands
- Unsupported FastEthernet or GigabitEthernet Interface Configuration Commands
- Unsupported Port-Channel Interface Configuration Commands
- Unsupported BVI Interface Configuration Commands
Unsupported CLI Commands
This appendix lists some of the command-line interface (CLI) commands that are not supported in this release, either because they are not tested, or because of hardware limitations. These unsupported commands are displayed when you enter the question mark (?) at the CLI prompt. This is not a complete list. Unsupported commands are listed by command mode.
Unsupported Privileged Exec Commands
clear ip accounting
show ip accounting
show ip cache
show ip tcp header-compression
show ip mcache
show ip mpacket
show controller pos pm
show controller pos [variable] pm
Unsupported Global Configuration Commands
access-list aaa <1100-1199>
access-list aaa <200-299>
access-list aaa <700-799>
async-bootp
boot
bridge <num> acquire
bridge <num> address
bridge cmf
bridge <num> bitswap-layer3-addresses
bridge <num> circuit-group
bridge <num> domain
bridge <num> lat-service-filtering
bridge <num> protocol dec
bridge <num> protocol ibm
bridge <num> protocol vlan-bridge
chat-script
class-map match access-group
class-map match class-map
class-map match destination-address
class-map match mpls
class-map match protocol
class-map match qos-group
class-map match source-address
clns
define
dialer
dialer-list
downward-compatible-config
file
ip access-list log-update
ip access-list logging
ip address-pool
ip alias
ip bootp
ip gdp
ip local
ip reflexive-list
ip security
ip source-route
ip tcp
ipc
map-class
map-list
multilink
netbios
partition
policy-map class queue-limit
priority-list
queue-list
router iso-igrp
router mobile
service compress-config
service disable-ip-fast-frag
service exec-callback
service nagle
service old-slip-prompts
service pad
service slave-log
set privilege level
subscriber-policy
Unsupported POS Interface Configuration Commands
access-expression
autodetect
bridge-group x circuit-group
bridge-group x input-*
bridge-group x lat-compression
bridge-group x output-*
bridge-group x subscriber-loop-control
clock
clns
custom-queue-list
down-when-looped
fair-queue
flowcontrol
full-duplex
half-duplex
hold-queue
ip accounting
ip broadcast-address
ip load-sharing per-packet
ip route-cache
ip security
ip tcp
ip verify
iso-igrp
loopback
multilink-group
netbios
pos flag c2
pos mode gfp
pos scramble-spe
pos trigger delay
pos vcat defect <immediate | delayed>
pos vcat resequence
priority-group
pulse-time
random-detect
rate-limit
serial
service-policy history
source
timeout
transmit-interface
tx-ring-limit
Unsupported POS Interface Configuration Commands (Cisco Proprietary RPR Virtual Interface)
shutdown (unsupported on ML-Series cards not including ML1000-2)
Note With Cisco proprietary RPR, a shutdown of the SPR interface puts ML1000-2 cards in passthrough mode. This allows the card to participate in RI. ML1000-2 cards are the only ML-Series cards eligible for RI. Other ML-Series cards fail to enter passthrough mode, when the SPR interface is shutdown.
Unsupported IEEE 802.17 RPR Interface Configuration Commands
bandwidth
cos priority-mcast
rpr-ieee clock-source
rpr-ieee count <mac addr>
rpr-ieee fairness active-weights-detect <span>
rpr-ieee fairness mode aggressive
rpr-ieee fairness mode conservative
rpr-ieee fairness multi-choke <span>
rpr-ieee framing
rpr-ieee loopback
rpr-ieee protection pref wrap
rpr-ieee protection sonet threshold sd-ber <value>
rpr-ieee protection sonet threshold sf-ber <value>
rpr-ieee trigger defects
rpr-ieee tx-traffic idle
Unsupported FastEthernet or GigabitEthernet Interface Configuration Commands
access-expression
clns
custom-queue-list
fair-queue
hold-queue
ip accounting
ip broadcast-address
ip load-sharing per-packet
ip route-cache
ip security
ip tcp
ip verify
iso-igrp
keepalive
loopback
max-reserved-bandwidth
multilink-group
netbios
priority-group
random-detect
rate-limit
service-policy history
timeout
transmit-interface
tx-ring-limit
Unsupported Port-Channel Interface Configuration Commands
access-expression
carrier-delay
cdp
clns
custom-queue-list
duplex
down-when-looped
encapsulation
fair-queue
flowcontrol
full-duplex
half-duplex
hold-queue
iso-igrp
keepalive
max-reserved-bandwidth
multilink-group
negotiation
netbios
ppp
priority-group
rate-limit
random-detect
timeout
tx-ring-limit
Unsupported BVI Interface Configuration Commands
access-expression
carrier-delay
cdp
clns
flowcontrol
hold-queue
iso-igrp
keepalive
l2protocol-tunnel
load-interval
max-reserved-bandwidth
mode
multilink-group
netbios
ntp
mtu
rate-limit
timeout
transmit-interface
tx-ring-limit