hw-module profile netflow sflow-enable
To enable sFlow on a specified node location, use the hw-module profile netflow sflow enable command in the configuration mode.
hw-module profile netflow sflow enable location node-id
Syntax Description
node-id |
The node-id argument is entered in the rack/slot/module notation. |
Command Default
sFlow is disabled
Command Modes
Configuration
Command History
Release | Modification |
---|---|
Release 7.2.12 |
This command was introduced. |
Usage Guidelines
The Netflow, IPFIX315 and sFlow features are mutually exclusive. Therefore, Netflow, IPFIX315 and sFlow should not be configured on the same node. However, some nodes can have Netflow, IPFIX315 and other nodes can have sFlow configurations.
You must reload the router for the configurations to take effect.
Examples
This example shows how to enable sFlow on the node location 0/0/CPU0:
Router(config)# hw-module profile netflow sflow-enable location 0/0/CPU0