Resolved Caveats – Cisco IOS XE Bengaluru 17.5.1
Caveat ID Number |
Description |
---|---|
TCAM related commands do not return values on RSP3 |
|
CPE SIT: IP Sec tunnel is not reachable after RSP3 SSO |
|
Config failure is seeen on standby RPS3 from 16_9_4 to 17_3_1 images upgrade |
|
Alarm-profile : APS configured for Au-4 mode T3, E3 after SSO alarms are removed |
|
Crash seen on "show plat hard pp active feature multicast database ipv4 table label <> eos <>" |
|
[SVSP-497]-Op state and Ad state showing NA for all slot with Bandwidth command |
|
OBFL updation with valid time after NTP Sync in RTC failure case (Rework of CSCvq07399) |
|
"no Loopback remote iboc csu/fac1/fac2" not brings remote end out of loop |
|
Crash of standby supervisor because of QoS Overhead Accounting |
|
sensor_state_change TDL message create validation missing |
|
UEA: Display GNSS Chassis SN instead of PCB SN in show CLI |
|
LOTR IM : RX-S1S0 bytes are not updated in "show controller sonet" |
|
Traffic not passing via BDI after physical interface flaps |
|
[RSP3 / PoCh-Mcast]: IGMP queries are dropped entering a Poch |
|
RSP3: copy recent standby logs and corefiles to Active |
|
[RSP3-DHCP-Relay]: DHCP relay unicast is dropped in transparent case with HSRP/VRRP/GLBP on EVC-BD |
|
RSP3-400S: OTN-Alarms behavior change using Alarm-Profile |
|
Auto negotiation failing when CU SFP connected to 100m port |