Configuring the DWDM-XFP-C Module
Perform the following procedure to configure the DWDM-XFP-C module.
SUMMARY STEPS
- enable source-interface gigabitethernet slot/port
- configure terminal
- interface tengigabitethernet slot/port
- itu channel number
DETAILED STEPS
Command or Action | Purpose | |
---|---|---|
Step 1 |
enable source-interface gigabitethernet slot/port Example:
|
Enables the privileged EXEC mode. If prompted, enter your password. |
Step 2 |
configure terminal Example:
|
Enters the global configuration mode. |
Step 3 |
interface tengigabitethernet slot/port Example:
|
Specifies the 10-Gigabit Ethernet interface to be configured. Here: slot/port—Specifies the location of the interface. |
Step 4 |
itu channel number Example:
|
Sets the ITU channel. number —Specifies the ITU channel number. The acceptable values are from 1–82. |
Verifying the ITU Configuration
The following example shows how to use the show hw-module subslot command to check an ITU configuration:
Router# enable
Router# conf t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#int tenGigabitEthernet 1/2/0
Router(config-if)#itu channel 20
Router(config-if)#
Router#
Router# show hw-module subslot 1/2 transceiver 0 idpr dump
Description = XFP optics (type 6)
Transceiver Type: = TUNABLE DWDM XFP (194)
Product Identifier (PID) = DWDM-XFP-C
Frequency Set for Tunable DWDM = 195.5 THz
Vendor Revision = 00
Serial Number (SN) = JFX1617800W
Vendor Name = CISCO-JDSU
Vendor OUI (IEEE company ID) = 00.01.9C (412)
CLEI code = IP9IAGGCAB
Cisco part number = 10-2544-02
Device State = Disabled.
XFP IDPROM Page 0x0:
000: 0C 00 49 00 F8 00 46 00 FB 00
010: 00 00 00 00 00 00 00 00 A6 04
020: 09 C4 8C A0 13 88 9B 83 13 93
030: 62 1F 1F 07 0F 8D 00 0A 09 CF
040: 00 10 00 18 FF E8 00 0C FF F4
050: 00 00 00 00 00 00 00 00 00 00
060: 00 BF 25 1C 00 C4 00 00 01 F4
070: 00 00 00 00 00 00 00 00 00 00
080: 00 00 00 00 9E 20 00 00 00 00
090: 00 00 00 00 00 00 1E 7C 00 00
100: 00 00 00 01 00 00 00 00 00 00
110: E2 98 00 14 00 00 00 00 00 00 <<See byte 113, the hexa decimal
equivalent for ITU channel 20>>
120: 00 00 00 00 00 00 00 01
XFP IDPROM Page 0x1:
128: 0C 98 07 00 00 00 00 00 00 00
138: 08 B4 63 71 50 00 00 00 00 9F
148: 43 49 53 43 4F 2D 4A 44 53