Introduction
Ce document décrit comment limiter la distribution à certains domaines ou hôtes.
Solution
La commande destconfig sur l'interface de ligne de commande ou la table des contrôles de destination sur l'onglet Politiques de messagerie dans l'interface graphique utilisateur peut être utilisée pour configurer la limitation du taux de remise sur l'appliance de sécurité de la messagerie Cisco à un domaine ou un hôte spécifique. Il est parfois recommandé d'activer cette option pour éviter de surcharger les hôtes distants.
Vous trouverez ci-dessous un exemple d'interface de ligne de commande sur la manière de limiter le débit de livraison au domaine « example.com ».
mail.example.com> destconfig
There are currently 2 entries configured.
Choose the operation you want to perform:
- NEW - Create a new entry.
- EDIT - Modify an entry.
- DELETE - Remove an entry.
- DEFAULT - Change the default.
- PRINT - Display all entries.
- CLEAR - Remove all entries.
[]> new
Enter the domain you wish to limit.
[]> example.com
Do you wish to configure a concurrency limit for example.com? [Y]>
Enter the max concurrency limit for "example.com".
[500]> 100
Do you wish to apply a recipient limit to this domain? [N]> y
Enter the number of minutes used to measure the recipient limit.
[60]> 60
Enter the max number of recipients per 60 minutes for "example.com".
[]> 1000
Select how you want to apply the limits for example.com:
1. One limit applies to the entire domain example.com
2. Separate limit for each mail exchanger IP address
[1]>
Select how the limits will be enforced:
1. System Wide
2. Per Virtual Gateway(tm)
[1]>
Do you wish to apply a specific TLS setting for this domain? [N]>
Do you wish to apply a specific bounce verification address tagging setting for this domain? [N]>
Do you wish to apply a specific bounce profile to this domain? [N]>
There are currently 3 entries configured
Choose the operation you want to perform:
- NEW - Create a new entry.
- EDIT - Modify an entry.
- DELETE - Remove an entry.
- DEFAULT - Change the default.
- PRINT - Display all entries.
- CLEAR - Remove all entries.
[]>
mail.example.com> commit