This document provides information about how to troubleshoot the Blue and Yellow T1 alarm.
There are no specific requirements for this document.
This document is not restricted to specific software and hardware versions.
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
Refer to Cisco Technical Tips Conventions for more information on document conventions.
For more information about the Receive Remote Alarm Indication (Yellow) chart, click these links that correspond to the command boxes in the graphic:
The box Insert the loopback plug into the port links to the Hard Plug Loopback Test.
The box Check the cabling links to T1 Alarm Troubleshooting.
The box Power cycle the router links to T1 Alarm Troubleshooting.
The box Connect the T1 line to a different port links to T1 Alarm Troubleshooting.
The box Perform a hardware loopback plug test links to the Hard Plug Loopback Test.
The box Error Events links to the T1 Error Event Troubleshooting Flowchart.
For more information about the Transmit Alarm Indication Signal (Blue) chart, click these links that correspond to the command boxes in the graphic:
The box Configure terminal controller t1 x framing {SF/ESF} links to T1 Alarm Troubleshooting.
The box Connect the T1 to a different port links to T1 Alarm Troubleshooting.
The box Perform a hardware loopback plug test on the original port links to the Hard Plug Loopback Test.
The box Error Events links to the T1 Error Event Troubleshooting Flowchart.
Revision | Publish Date | Comments |
---|---|---|
1.0 |
22-Oct-2018 |
Initial Release |