E1 Error Event Troubleshooting Flowchart

Available Languages

Download Options

PDF (46.0 KB)
View with Adobe Reader on a variety of devices

Updated:February 28, 2008

Document ID:14161

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

Prerequisites

Requirements

Components Used

Conventions

Background Information

Related Information

Introduction

This document provides information about how to troubleshoot the E1 error event.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

This document is not restricted to specific software and hardware versions.

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Conventions

Refer to Cisco Technical Tips Conventions for more information on document conventions.

Background Information

For more information about the Error Events chart, click these links that correspond to the command boxes in the graphic:

The box Configure terminal controller e1x clock source line primary links to the Slip Secs Counter Increasing section of E1 Error Events Troubleshooting.
The box Use the show controller e1x command links to the Introduction section of E1 Error Events Troubleshooting.
The box Configure terminal controller e1x framing cr4 / no-crc4 links to the Framing Loss Seconds Increasing section of E1 Error Events Troubleshooting.
The box Configure terminal controller e1x framing cr4 / no-crc4 links to the Line Code Violations Increasing section of E1 Error Events Troubleshooting.
The box Configure terminal controller isdn switch-type primary-net5 links to the Verifying the isdn switch-type and pri-group timeslots Configuration section of E1 Error Events Troubleshooting.
The box Check the d channel using the show interface ser x:15 command links to the Verifying the Signaling Channel section of E1 Error Events Troubleshooting.
The box Configure terminal interface serial x:15 no shutdown links to the Verifying the Signaling Channel section of E1 Error Events Troubleshooting.
The box Configure terminal interface serial x:15 encapsulation ppp links to the Verifying the Signaling Channel section of E1 Error Events Troubleshooting.
The box Configure terminal interface serial x:15 no loopback links to the Verifying the Signaling Channel section of E1 Error Events Troubleshooting.