Internet Protocol version 4 (IPv4) directs most Internet traffic currently, but Internet Protocol version 6 (IPv6) is also a popular choice. IPv4 contains a limited number of IP addresses for devices and networks to use. To address this problem, IPv6 contains more IP addresses. When a site or user needs to send IPv6 packets over an IPv4 network, 6to4 is useful. 6to4 does not send IPv6 packets to IPv4 sources. It only uses IPv4 for transportation. On the RV110W, a user can set the Local Area Network (LAN) and the Wide Area Network (WAN) to IPv4 or IPv6. This article explains how to configure the IP Mode on the RV110W.
Step 1. Use the web configuration utility to choose Networking > IP Mode.
Step 2. From the IP Mode drop-down menu, choose a LAN and WAN setting.
Step 3. Click Save to save changes or Cancel to discard them.
Step 1. Click Show Static 6to4 DNS Entry to show the Static 6to4 DNS Entry fields.
Step 2. In the Domain 01 Field, enter a domain, and enter the IP address for the domain to be mapped to in the IP 01 field. Repeat this step in the proceeding fields if you wish.
Step 3. Click Save to save changes or Cancel to discard them.