Configure DHCP on RV110W

Available Languages

Download Options

  • PDF     (475.0 KB)
    View with Adobe Reader on a variety of devices
  • ePub     (510.6 KB)
    View in various apps on iPhone, iPad, Android, Sony Reader, or Windows Phone
  • Mobi (Kindle)     (191.6 KB)
    View on Kindle device or Kindle app on multiple devices
Updated:December 11, 2018
Document ID:SMB2337

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Configure DHCP on RV110W

 Objective

DHCP is a type of protocol configuration for hosts that wish to communicate over the network. A DHCP server is responsible for handing out network parameters, such as IP addresses, to devices on the network that request them. Without DHCP, each device on a network would need to be configured manually.

The objective of this document is to show you on how to configure the DHCP WAN settings on the RV110W.

Applicable Devices

• RV110W

Configuring DHCP

Step 1. In the web configuration utility, choose Networking > WAN.

Step 2. From the Internet Connection Type drop-down list, choose Automatic Configuration - DHCP.

Step 3. (Optional) Enter the host name of the RV110W in the Host Name field.

Note: If you do not wish configure any of the optional settings, then skip to Step 7.

Step 4. Enter the domain name of your network in the Domain Name field.

Step 5. Click Auto to have the size of the MTU automatically adjust, or click Manual to specify the size of the MTU.

Step 6. If you click Manual, enter the size of the MTU in the Size field.

Step 7. Click Save to save the configuration changes, or click Cancel to discard them.

Was this Document Helpful?

FeedbackFeedback

Contact Cisco